Table of Contents
Advertisement
Alarm Output: This will transmit a signal through the alarm output relay. It can be set to either "NONE" (not
active), "1" (active).
Output Type: Output action when alarm is triggered.
Timeout: Alarm output lasts for the set time duration.
Permanent: Alarm will be continuously active until user presses "Enter" key.
Transparent: Alarm output remains active until event ends.
Trans+Timeout: Alarm output continues until event ends, then lasts for the set time duration.
Timeout Duration: The amount of time the alarm action will be active when a GPS event occurs. Duration
selectable from 1 to 150 seconds.
Pre-alarm Record: Check box to start copying recorded video to the storage device from 5 seconds before the
video loss. (Pre-alarm recording rate will follow the "Normal" frame rate setting)
Email Notify: Check box to enable email notification when GPS event occurs. Email operation requires that valid
email settings have been entered in the Network Setting/Email setup screen.
Network Alarm: Check box to send out a network alarm to client PC. (requires CMS software, including
EverFocus' PowerCon or PowerVideo Plus, and setting up Alarm Server in Network Setup menu)
5.3.7
Alarm – GPS Fencing
Press
menu.
GPS Alarm: Select "On" to enable GPS alarm. Select "Off" to disable GPS alarm function.
GPS Border Type: Set to a circle or rectangle and dynamic prompts for Latitude and Longitude appear.
Coordinate Express: This field lets you select how you enter your border coordinates, either by Decimal Degrees,
or by DMS (degree, minute, second).
Center Latitude: Set the latitude if the border type is a circle.
Center Longitude: Set the latitude if the border type is a circle.
Radius: If the GPS border type is a circle, this option defines the radius. Select radius unit from Km and Mi.
at the bottom of the Alarm – GPS Speed menu to enter the GPS Fencing
Alarm – GPS Fencing
38
Advertisement
Table of Contents
