Weak Or Hard To Hear Audio - Uniden XDECT 7055 Owner's Manual

If...
The answering
system won't record
messages.
A handset can't access
the answering system.
My outgoing message
is gone.
I can't hear the base
speaker.
Messages are
incomplete.
The system keeps
recording if I answer
on an extension.
I can't register a
handset.

Weak or hard To hear Audio

If a caller's voice sounds weak or soft, the signal might be blocked by
large metal objects or walls; you might also be too far from the base,
or the handset's battery may be weak.
Try moving around while you're on a call or moving closer to the

base to see if the sound gets louder.
 Make sure the handset's battery is fully charged.
Try adjusting the earpiece volume or the audio tone (see below1.

Adjust the audio tone
During a call, open the menu and select Audio Tone. Choose one of
the three audio tone options: High Tone, Natural Tone (recommended
for hearing aid users1, or Low Tone. You may have to experiment to
figure out which audio tone works best for you.
Try...
Making sure the
-
Announce Only.
Deleting messages (the memory may be full).
-
Making sure no other handset is using the system.
-
Making sure the phone is in standby.
-
Seeing if there was a power failure. You may have to
-
re-record your personal outgoing message.
Making sure call screening is turned on.
-
Changing the base speaker volume.
-
The incoming messages may be too long. Remind
-
callers to leave a brief message.
Deleting messages (the memory may be full).
-
You may have to change the line mode. Visit the
-
website for more information.
Seeing if you already have 6 handsets registered to
-
this base.
Resetting the handset.
-
Record Time is not set to
25