Resetting And Registering Handsets - Uniden XDECT 7055 Owner's Manual

this problem. The technician who installed your DSL service might
have left some filters for you; if not, call your DSL provider or look in
any electronics store.
Plug the DSL filter into the telephone wall jack and plug your phone's
base into the filter. Make a test call to make sure the noise is gone.

resetting and registering handsets

If you are having trouble with a handset or if you want to replace one,
you need to clear the registration information from the base and the
handset:
Do you have the base the handset is registered to?
1. Press & hold
System Reset menu appears (about 5
seconds).
2. Select Deregister HS. The display lists
all registered handsets.
3. Select the handset you want to reset.
4. When the phone asks you to confirm,
select Yes. The handset clears its
information from the base & deletes it
own link to the base.
When you reset a handset (or if you buy a new one1, that handset
displays a Handset Not Registered message. If you see this message
on a handset, you need to register it to a base before you can use it.
Registering a handset
Does the handset fit in the base cradle?
Yes
Place the handset in
the base.
The display should say
Handset Registering.
In about 30 seconds, the handset display should say Registration Complete.
Press
TALK ( )/FLASh
Yes
and until the
END ( ) #
1. On the base, open the menu and select
Handset. The display should say Handset
Registering.
2. On the handset you want to register, press and
hold # until the handset display says Handset
Registering (about 2 seconds).
and make sure you get a dial tone.
No
1. Press & hold
the System Reset menu
appears (about 5 seconds).
2. Select Base Unavailable.
3. When the phone asks you
to confirm, select Yes. The
handset deletes its own link
without contacting the base.
No
and until
END #
Register
27