Removal; How To... Replace The Striding Belt And Deck - Life Fitness T3 Service Manual

Life Fitness T-Series Consumer Treadmills

How To... Replace The Striding Belt and Deck

Tools Required: Hex key wrench set, socket and ratchet set, Phillips screwdriver, Torx wrench set, tape measure,
and open end wrench set

REMOVAL

REMOVAL REMOVAL REMOVAL
1. At the power switch, turn OFF the unit, then
unplug the line cord at the wall outlet.
2. Remove the motor cover screws(2) under the
front of the motor cover, then lift the rear
portion of the motor cover from the dual lock
tape.
3. Remove the left and right end caps by
removing mounting screws(2) from each end
cap.
4. Remove the mounting screw at the front of
the left and one at right front extrusion. Slide
each extrusion back
mounting brackets(8).
5. Remove extrusion brackets(8)
and screws(16) from the deck
and set aside to be remounted
on the new deck.
NOTE: Before removing the rear
roller, scribe an "L" (left) and an "R"
(right) on the ends of the roller shaft.
This will ensure that the roller
bearings maintain same direction
wear pattern. Mark the position of
the belt tensioning bolts for later
reference.
6. Remove rear roller tensioning
bolts.
7. Remove the rear roller.
2
off the extrusion
Extrusion
Bracket(8)
Rear Roller
Tensioning Bolt(2)
End Cap
Screws(4)
Section 3
Motor
Cover
Power
Switch
Motor
Cover
Screws
Rear
Roller
End Cap(2)
Dual
Lock
Tape
Extrusion
Screw(2)
Extrusion(2)