Program Values - Bosch C 1210 ES Installation Manual

6.6

Program values

This section describes details on programming the
appliance. For most applications the factory default val-
ues will provide robust and stable operation. Only
adjust the factory settings if the installation requires
changes as indicated in the appropriate section of this
manual.
Program Description
P0 Temperature range
settings
P1 Maximum Fan
Speed Power
P2 Minimum Fan
Speed Power
P3 Remote Control
Registration
P4 Access to
Diagnostic Mode
P5 Cascade Mode
P6 Temperature Unit
P8 Back light
P9 Fan Purge
PH Cascading type
PC Master/Slave
mode
Table 25 Program values, factory default settings and ranges.
6 720 644 887
Factory Default MIN
_
H: C 1210 ES
C: C 1210 ESC
NG:52, LP:53 21
12 12
_0 _0
E 0d
NO NO
°F °F
dE dE
IC IC
CS CS
Refer to chapter 6.7 Control board diagnostics (page
35) regarding how to access these P-modes.
Caution: Misadjusted
values can
malfunction, errors, and service
calls.
MAX Comment
_ This values are set from factory
they cannot be changed.
NG:52, LP:53 see chapter 3.14, page 35
note: reducing P1 values below
maximum will reduce maximum
power of the appliance.
20 see chapter 3.3.7, page 20
6 see chapter 5.5, page 39
10F see chapter 6.7, page 46
CC contact Bosch
Thermotechnology for details
°C
ON dE turns back light off after 60
seconds
pushed, ON turns backlight on
permanently
runs primary and secondary
fans when P9 is selected by
depressing the "P" - button
SC This menu is only available
when cascade mode is selected
CC.
Contact Bosch Water Heating
CM
for details.
Maintenance and service
program
lead to appliance
from last button
45