Program Values - Bosch Therm 8000 S GWHC 27 CTDE Installation And Operating Instructions Manual

32 | Installation instructions

8.4 Program values

This section describes details on programming the appliance.
For most applications the fact ory default values will provide
robust and stable operation.
Program Description
P1 Maximum Power N. Gas: 45
P2 Minimum Power 12
P3 Remote
Controls installed
P4 Access to
Diagnostic Mode
P5 Cascade Mode
P6 Temperature Unit ºC
P7 Appliance Type
P8 Back light
P9 Fan Purge
PH Cascading type
PC Master/Slave modeCS
Table 13
6 720 680 174 (2012/09)
Factory default Min
21
LPG: 39
12
_0 _0
E 0d
nO nO
ºF
Cd Cd
(Condensing) (Condensing)
dE dE
IC IC
CS
CAUTION: Misadjusted program values
can lead to appliance malfunction, errors,
and service calls.
Max Comment
N. Gas: 45 See chapter 8.2.
LPG: 39 Note: reducing P1 values below maximum
will reduce maximum power of the
appliance.
20 See chapter 8.2.
6 See chapter 4.6.
10f See chapter 8.5.
CC To activate the cascade mode it's
necessary to install the "kit cascade" (cod.
7 736 500 272)
ºC See chapter 8.5.
nC Condensing / Non-condensing
note: incorrect setting will cause errors.
On dE: turns back light o after 60 seconds
from last button pushed.
ON: turns backlight on permanently.
Runs secondary fan and primary fan when
P9 is selected by depressing the "P" -
button
SC
This menu is only available when cascade
mode is selected CC.
CM
Therm 8000 S