Program Values - Bosch Therm 6000 S Installation And Operating Instructions Manual

8.4

Program values

This section describes details on programming the appliance.
For most applications the factory default values will provide
robust and stable operation.
Program Description
P1 Maximum Power
P2 Minimum Power
P3 Remote
Controls installed
P4 Access to
Diagnostic Mode
P5 Cascade Mode
P6 Temperature Unit °C
P7 Appliance Type
P8 Back light
P9 Fan Purge
PH Cascading type
PC Master/Slave
mode
Table 12
Therm 6000S
Factory default Min
N. Gas: 40 21
LPG: 37
N. Gas: 8 N. Gas: 8
LPG: 7 LPG: 7
_0 _0
E 0d
nO nO
°F
nO Cd
(condensing)
dE dE
IC IC
CS CS
CAUTION: Misadjusted program values
can lead to appliance malfunction, errors,
and service calls.
Max Comment
N. Gas: 40 See chapter 8.2.
LPG: 37 Note: reducing P1 values below maximum
will reduce maximum power of the
appliance.
20 See chapter 8.2.
6 See chapter 4.6.
10f See chapter 8.5.
CC To activate the cascade mode it's necessary
to install the "kit cascade" (cod. 7 736 500
272)
°C See chapter 8.5.
nO Condensing / Non-condensing
note: incorrect setting will cause errors.
On dE: turns back light off after 60 seconds
from last button pushed.
ON: turns backlight on permanently.
Runs secondary fan and primary fan when
P9 is selected by depressing the "P" - button
SC
This menu is only available when cascade
mode is selected CC.
Cn
Installation instructions | 29
6 720 800 095 (2015/11)