DGS-6600 Layer 3 Chassis Ethernet Managed Switch Hardware Installation Guide
Fan Tray Installation
The DGS-6600-FAN fan tray is used by the DGS-6600 Series Switch as a ventilation system. Follow the
instructions below to correctly install the fan tray:
1. Use the thumb-screws to remove the fan tray blank panel.
2. Insert the fan tray into the guide rail of the fan tray slot.
3. Secure the fan tray by tightening the fan tray's captive-screws.
Figure 2-4 Schematic diagram for installing the fan tray in the DGS-6604
41