Inspecting Burners - Superior Fireplaces VRE3036ZMN Installation And Operation Instructions Manual

OPERATION
Continued
HAND-HELD
REMOTE OPERATION
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 12.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi-
tion. Adjust flame adjustment knob any-
where between HI and LO. Slide the se-
lector switch to the REMOTE position
on Remote Receiver (see Figure 19).
Check pilot flame pattern and burner flame
patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the
proper flame height. Alterations may have
occurred during shipping and handling. Call
a qualified service person to readjust the pilot
if necessary.
The height of the thermopile must be 3/8" to
1/2" above the pilot flame as shown in Figure
22. The thermocouple must be at a height of
about 1/8" above the pilot flame. The flame
from the pilot burner must extend beyond both
the thermocouple and thermopile.
If you pilot assembly does not meet these
requirements:
• turn fireplace off (see To Turn Off Gas to
Appliance, page 12)
• see Troubleshooting, page 17
BURNER FLAME PATTERN
Figure 23 shows correct burner flame pattern.
NOTICE: Do not mistake orange
flames with yellow tipping. Dirt
or other fine particles are burned
by appliance, causing brief
patches of orange flame.
If burner flame pattern is incorrect, as shown
in Figure 24.
• turn appliance off (see To Turn Off Gas to
Appliance, page 12)
• see Troubleshooting, page 17
14

INSPECTING BURNERS

www.SuperiorFireplaces.US.com
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on
and off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Control Knob
Flame
Piezo
Adjustment
Ignitor
Knob
Figure 19 - Settings for Remote Operation
Thermopile
3/8" to 1/2"
Piezo
Ignitor
Figure 22 - Pilot Assembly
Figure 23 - Correct Burner Flame Pattern
Figure 24 - Incorrect Burner Flame
REMOTE
OFF
ON
Selector Switch in
REMOTE Position
Pilot Burner
Thermocouple
Yellow Flames with
Orange Streaks
Dark Orange
Flames
Pattern
127042-01A
1/8"