Connecting The Microphone - Uniden UH7750NB Owner's Manual

Connecting the Microphone

UH7740NB UH7750NB
Front MIC Jack
Push the MIC plug at the end of the microphone into the MIC jack until the connection
locks into place. Gently tug the MIC cord to test that the connection is locked. Use the
Front MIC Jack cover which is threaded onto the MIC cord to seal the MIC jack entry
from dust.
Disconnecting the MIC from the Front MIC Jack
Pull away the threaded rubber collar and move it down along the cord. Using
the flat blade of a screwdriver or similar object carefully press the lock tab at the
bottom (UH7750NB) or left (UH7740NB) side of the MIC plug and push it upwards
(UH7750NB) or to the right (UH7740NB). At the same time tug on the MIC cord to draw
back the MIC plug.
Rear MIC Jack
Use the Rear MIC Jack if the main base is mounted where a front MIC connection is
intrusive or if you wish to use the Remote LCD Speaker MIC with an optional extension
cable.
Peel the dust cover from the rear MIC jack. Push the MIC plug at the end of the
microphone into the MIC jack until the connection locks into place. An optional 2m
extension cable kit is available to enable mounting the main base in a hidden location.
The Front and Rear MIC JACKs can not be used at the same time.
NOTE
14
UNIDEN UH7740NB UH7750NB UHF CB Transceiver