Din-E Installation (Uh7750 Only) - Uniden UH7750NB Owner's Manual

DIN-E Installation
Mounting Using the DIN-E Sleeve
If you are unsure about how to install your UH7750NB in your vehicle using the DIN-E
sleeve, consult your automobile manufacturer, dealer, or a qualified installer. Before
installing, confirm that your UH7750NB fits in the desired mounting area and you have
all the necessary materials to complete the task. Your UH7750NB requires a 53 x 183 x
86 mm mounting area. Allow an additional 60 mm space behind the unit for connectors
and wires.
1. Remove the bracket if previously attached.
2. Install the DIN-E sleeve into the opening in your dashboard, lip facing out.
3. Push out the top and bottom tabs to hold the sleeve firmly in place.
4. Remove the rubber ring fitted around the cabinet sides near the front of the
UH7750NB. Store the rubber ring in a safe place for future use.
5. Before inserting the UH7750NB in the sleeve, attach the cable from the previously
mounted antenna. Attach the DC Power leads. RED goes to a positive (+)
connection on your fuse block while BLACK connects to the vehicles chassis
ground (-). Be sure all the connections are routed away from any potentially
pinching or slicing sheet metal.
6. Slowly slide the UH7750NB into the sleeve until it locks in place.
If you plan to use the Rear MIC Jack or connect an external speaker
at a later time, expect to remove the unit for ease of making those
connections.
NOTE
UNIDEN UH7740NB UH7750NB
(UH7750NB only)
12
UHF CB Transceiver