Menus For Other Camera Settings - Olympus Fe-370 Instruction Manual

Menus for Other Camera Settings
These settings can be made when the mode dial is set to a position other than GUIDE.
Erasing data completely
{MEMORY FORMAT]I{FORMAT]
.j1t
S,EIue,,"_MEMQRY_EORMATLEQaM~'L_
o
Before formatting, check that no important
data is left in the internal memory or card.
e
Non-Olympus cards and cards that have
been formatted by a computer must be
formatted with this camera before use.
., Be sure to remove the card before formatting the
internal memory.
Copying images in the internal memory
to the card (BACKUP]
, \1' . .
SEIUP~~
BACKUE..-_._,
~
.. ._
YES
YES
Completely erases the image data
in the internal memory" or card
(including protected images).
Cancels formatting.
Backs up image data in the
internal memory to the card.
Cancels the backup.
Adjusting the CCD and adjusting
the image processing function
{PIXEL MAPPING]
. vt.SEIUE ~_EJXELMAPPING .•.. ."
__ .......................... _..."0 .•
~ .
_ _...."..
v .. . . . , , ' - ' - " " " ' " - ,...,.""'",,.....-., """,v.
, ~ " ' ~
....
> . - . " ' < M ~ . ,
......,.
10
This function has already been adjusted
at factory shipping, and no adjustment is
needed right after purchase. Approximately
once a year is recommended.
o
For best results, wait at least one minute
after taking or viewing pictures before
performing pixel mapping. If the camera is
turned off during pixel mapping, be sure to
perform it again.
To adjust the CCO and to adjust the
image processing function
Press the
@
button when [START]
(Submenu 2) is displayed.
• The camera checks and adjusts the CCD and the
image processing function at the same time.
Turning
on
the camera with the
t:j
or
{B button {DI{B]
;._'t!..§EI:;;,Y~~~JC'£~=='o;:·:::.;;:;.;;;:.-:;;-~~=:;:::;;;;;:,:;
f)
It takes some time to back up data. Check
that the battery has sufficient power before
starting the backup.
Changing the display language { • .@]
•.
~::§5:I~f~~~td§b::;:::;::::::;:;.,,'~.:::;::::;:;:::;:::::::::..~~_::;;:;;;:::
• "Changing the display language" (p. 13)
The language for the menus and
Languages" error messages displayed on the
monitor is selected.
., The available languages vary depending on the
country and/or region where the camera was
purchased.
YES
Pressing the
Q
button turns on
the camera and starts the camera
in the shooting mode.
Pressing the
1El
button turns on
the camera and starts the camera
in the playback mode.
The power is not turned on. To turn
on the camera, press the POWER
button.