Troubleshooting - Husqvarna Viking Viking Royale User Manual

TROUBLESHOOTING

Have Your Sewing Machine Serviced Regularly by your Local Authorized Retailer!
If you have followed this troubleshooting information and still have problems, take your sewing machine to your retailer.
your retailer. A sewing sample will often give much better information than words.
General Problems
Bobbin alarm does not work?
Thread cutter does not cut the thread?
Wrong stitch, irregular or narrow stitch?
The needle breaks?
The machine will not sew?
The screen displays the startup screen?
Icons on the screen are not activated when touched?
The sewing and embroidery machine screen
and/or function buttons do not respond to
touch?
Needle Thread Breaks
Did you insert the needle properly?
Did you insert a wrong needle?
Is the needle bent or blunt?
Is the needle too small for the thread?
Is the needle plate hole damaged?
Did you thread the machine properly?
Are you using poor thread with slubs or
thread which has become dry?
Is a correct spool cap used?
Is the best spool pin position used?
Bobbin Thread Breaks
Did you insert the bobbin properly?
Is the needle plate hole damaged?
Is the bobbin area full of lint?
Is the bobbin wound correctly?
VIKING bobbins approved for this model.
®
Remove needle plate and clean lint from bobbin area.
Enable automatic thread cutter in the SET Menu.
Deactivate Twin Needle or Stitch Width Safety Sewing Settings in the SET Menu.
Insert needle correctly as described in chapter 2.
Check that all plugs are securely plugged into the machine and into the wall socket.
Touch the screen to activate.
Calibrate the screen. Calibrate is found in the SET Menu.
The sockets and function buttons on the machine can be sensitive to static
electricity. If the screen does not respond to touch, turn the machine
Insert needle correctly as described in chapter 2.
Use needle system 130/705 H.
Insert a new needle.
Change the needle to the proper size for the thread.
Change the needle plate.
Check how the machine is threaded. If needed rethread the machine.
Attach a spool cap of the right size for the actual thread spool (see chapter 2).
Check the bobbin thread.
Change the needle plate.
Clean lint from bobbin area and use only the original bobbins approved
for this model.
Wind a new bobbin.
retailer who will be happy to help you.
®
® retailer.
retailer.
®
M 10:3
AINTENANCE