Rj-11 Jack Cable - HP ProBook 4535s Service Manual

RJ-11 jack cable

NOTE: The RJ-11 jack cable is included in the Cable Kit, spare part number 646303-001.
Before removing the RJ-11 jack cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Bottom door (see
b. Optical drive (see
c. Modem module (see
d. Keyboard (see
e. Top cover (see
f. USB board (see
Remove the RJ-11 jack cable:
1. Position the computer upright with the front toward you.
2. Remove the tape (1) that secures the cable to the computer.
3. Remove the RJ-11 jack cable from the clips and routing channel (2) built into the base
enclosure.
Battery on page 41).
Bottom door on page
Optical drive on page
Modem module on page
Keyboard on page 57)
Top cover on page 59)
USB board on page 73)
43).
44)
70)
Component replacement procedures 75