Rj-11 Jack Cable - HP ProBook 4430s Maintenance And Service Manual

RJ-11 jack cable

NOTE:
The RJ-11 jack cable is included in the Cable Kit, spare part number 646369-001.
Before removing the RJ-11 jack cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Bottom door (see
b. Hard drive (see
c. Optical drive (see
d. WLAN module (see
e.
WWAN module (see
f.
Modem module (see
g.
Fan (see
h.
Heat sink (see
i.
Keyboard (see
j.
Top cover (see
Remove the RJ-11 jack cable:
1.
Position the computer right-side up with the front toward you.
2. Remove the tape (1) that secures the cable to the computer.
3. Remove the RJ-11 jack cable from the clips and routing channel (2) built into the base enclosure.
84 Chapter 4 Removal and replacement procedures
Battery on page
Bottom door on page
Hard drive on page
Optical drive on page
WLAN/Bluetooth combo card on page
WWAN module on page
Modem module on page
Fan on page 65)
Heat sink on page
Keyboard on page
Top cover on page
46).
48).
51)
49)
55)
78)
67)
62)
69)
57)