Panasonic KX-TCD700 Operating Instructions Manual page 56

28426_English 19/10/00
➡
Before Requesting Help
Problem
While programming or searching,
the unit starts to ring and stops
the program/search.
The unit does not display the
caller's phone numbers.
Ï does not function.
You cannot redial.
The paged handset does not
answer.
While using the intercom, two tones
sound.
The unit misdials when connected
to a PBX.
You cannot register the handset
in the base unit.
The battery strength is not
displayed correctly.
12:19 pm Page 56
• To answer the call, lift the handset or Z O.
• Start again from the beginning after hanging up.
• Other telephone equipment may be interfering with
• your phone. Disconnect them and try again.
• Other electrical appliances connected to the same
outlet may be interfering with the Caller ID
information. Telephone line noise may be affecting
the Caller ID information.
• The handset is too far from the base unit.
• The handset is engaged in an outside call. Wait until
the in use indicator  light goes on.
• If the last number dialled was more than 24 digits
long, the number will not be redialled.
• The handset is not in the same radio area.
• The handset is engaged in an outside call.
• The handset has been cancelled or has not been
registered. Register the handset in the base unit
(p.00).
• A call is being received. To answer, Z O twice.
• Check the pause function (p.00).
• The base unit has registered a maximum of 6
• handsets or the handset has registered a maximum
of 4 base units.
• A wrong base unit password was entered. Enter the
correct password.
• There is interference from other electrical units,
Locate the handset and base unit away from them.
• You must finish registration within 1 minute after the
ringer tone sounds, or programming will be
cancelled (p.00).
• Check that the battery type selection is correct
• (p.00).
56
Remedy