Table of Contents
Advertisement
o
Turn on the power of your TV.
o
Select the appropriate video input
on your TV.
If Ihe aso video pin
cable
is connected to the video input 1 on
the TV as shown in the connection example 1, switch the video
Input to"'".
Set the operation mode selector to
YSP.
This unit switches to the YSP operation mode
Press and hold AUTO SETUP for
more than 2 seconds.
The menu screen appears on the TV.
If the menu screen does nol appear, check Ihe
eso
video pm
cable (see the connection example on the fronl page).
CD
Check the following points.
About the lnlelliBeam microphone
• Is the microphone placed on an Imaginary center hne drawn
from this unit?
• Is Ihe microphone placed within 1 m (3.3 It) upper or lower
from the center heigl'll ollhis unit?
• Is the microphone placed more than 1.8 m (6.0 II) from the
Ironl of this unit?
About the room environment
• Is your listening room kept as
qUiet
as possible?
Gil
Prepare to leave the room.
The best setting may not
be
done
if
you are in Ihe room.
Prepare to leave the room In 10 seconds alter pressing ENTER
In step 11
G)
Press ENTER to start the AUTO
SETUP procedure, and then leave
the room within 10 seconds.
The lollowing screen appears on the TV Leave the room wlth!n
10 seconds before the AUTO SETUP procedure starts.
The setup screen automatically changes dUring the AUTO
SETUP procedure.
When the AUTO SETUP procedure IS completed, the following
screen appears on the
TV.
II "ENVIRONMENT CHECK (FAILED) IS displayed. see page 34
in the Owner's Manual and then run the procedure again.
i.,
Hll1t
• The result may dllter depending on the environment.
• It
any error occurs, the corresponding error message appears
on the screen. In this case. see "Error messages 'or AUTO
SETUP'" on page
35
In the owner's Manual ana Inen loliow
the instructions. To starllhe AUTO SETUP proceclure once
again, press RETURN
Press ENTER.
The 'allOWing screen appears on the
TV
for
2
seconds and then
the menu screen disappears Irom the
TV.
Gl
Disconnect the IntelliBeam
microphone.
The AUTO SETUP has completed. Keep the IntelhBeam
microphone
In
a sa'e place.
The setlJngs are automatically saved
In
the system memory.
• When leaVing the room. bnng thiS gUide With you.
• Wait outside the room during the AUTO SETUP procedure.
• The AUTO SETUP procedure lakes aboul 3 minutes
• To cancel the AUTO SETUP procedure after It is started,
press RETURN.
•
Advertisement
Table of Contents
