Connecting Cable; Wrist Adaptor - Seiko RC-4000 Instruction Manual

2. Connecting cable
The RC-4000/4400 is connected to a
personal computer using a special connect-
ing cable. There are cables available for
the Apple II, II+, lie. Me, Commodore
64, IBM-PC, and most compatibles. For
details, please ask your dealer.
(1) Insert the jack on connecting cable into
socket in wrist plug. When connecting
hold the wrist plug firmly.
(2) To disconnect, again hold the wrist
plug firmly. Take hold of jack plug and
remove.
* Do not pull on the cable as this could
break the wire inside.
How to attach to the RC-4400
Insert the jack plug on the connecting
cable into the socket in the pocket model.
32
3. Wrist adaptor (RC-4300)
The wrist adaptor is used when data is transmitted to other RC-4000/4400. For the
method of data transmission refer to "How to transmit and receive data from another RC-
4000/4400" on page 20.
RC-4300
How to connect to RC-4000
(1) Insert the jack plug on the wrist adaptor into the socket on the wrist plug. (The wrist plug
is unnecessary for the RC-4400.)
(2) To disconnect, grip the jack plug firmly on the receiving RC-4000 side and the adaptor
on the transmission RC-4000 side. Do not disconnect by pulling on the cable as this could
break the wire inside.
To disconnect the RC-4000 from the wrist plug, refer to "Wrist plug" on page 31.
Note: Take care to avoid contact of the 2 jack plugs on the wrist adaptor as this will cause
shorting of the battery.
33