Seiko RC-4000 Instruction Manual page 13

(2) Switch over to "DATA OUT (H)" or "DATA OUT
(L)" to start transmission by pressing button B. Refer
to "Precautions for Data Transmission Mode".
(3) A beep sound is heard as soon as the transmission
starts.
(4) When the transmission is completed, another beep
sound is heard and the display reverts to the Time
Display Mode.
Notes on Data Transfer with a personal computer
* Be sure that transfer is carried out correctly. If not, previous data in the reception RC-
4000/4400 may be erased or the reception RC-4000/4400 may be all cleared.
* The procedures shown herein are different according to the personal computer and the
software used. For details, refer to your software's Instruction Manual.
24
4. Precautions for Data Transmission Mode
(1) Before starting data transmission, make sure that all the connections are correctly made.
(21 During data transmission, avoid touching the buttons or cables which may cause a mis-
transmission or. erase data.
(3) There are two transfer speeds — High (H), which transfers the information in 10 seconds,
and Low (L) with a transfer speed of 80 seconds. One push of button A in the Time
Display Mode will change the display to "DATA IN (H)"; one more push changes it to
"DATA IN (L)". Both the reception and transmission should be set at the same speed.
©,
DflTfl IN (L)
Data input erases previous data
As soon as data transfer starts, the previous data is erased as the new data is input. Also, if
data transfer fails, previous data is erased. If display reverts to the Time Display Mode while
in "DATA IN (H)" mode, data will not be erased.
* Before switching to "DATA OUT (H)" mode, make sure that all the necessary connections
have been completed.
* All the data will be erased when the battery is exhausted.
25