Usb 1.1 Specifications; Printing Via The Optional Wireless Lan Interface - SATO MB400i Operator's Manual

USB 1.1 SPECIFICATIONS

The Universal Serial Bus (USB) interface is a factory installed option that must be specified at the
time of order. It required a driver (shipped with each printer that has the interface installed) that
must be loaded on your PC and the PC must be configured to support USB peripherals using
Microsoft Windows. Details for loading the USB driver are contained in the USB Interface
manual that is shipped with each printer with a USB Optional interface installed. Up to 127
devices may be connected to a USB port.
Transfer Rate
Communication Control
Code type
Connector
Max. Receive buffer

PRINTING VIA THE OPTIONAL WIRELESS LAN INTERFACE

To print using the Wireless LAN MB400i/410i, you need to have a properly configured wireless
LAN set up. The next step is to configure the MB400i/410i to share the same network settings in
order to establish communication.
1. Check the DIP Switches:
The printer's DIP switches are factory set for WLAN operation. Check that DIP switch 1 is
OFF and DIP switch 2 is ON. In case you need to reset other switches, refer to the DIP-Switch
settings in the table, Enabling and Disabling Special Functions, in the chapter, Operating
Modes.
MB400i/MB410i Operator Manual
USB 1.1 SPECIFICATIONS
11Mbits per second
STATUS3 return
ASCII character code, JIS Kanji code
Mini B type
128 KB
When implementing the flow control into the hardware, the flow
control will activate when "buffer full" is detected and deactivate
as soon as "buffer full" is released. During that span the flow
control manages the information flow and prevents a buffer
overflow.
0MB
Near full
occured
Near full
released
Unit 4: Operation and Configuration
128KB
Remaining 24KB
Remaining 52KB
Page 4-9