Loading The Label Roll (Continuous Mode) - SATO MB400i Operator's Manual

Hide thumbs Also See for MB400i:

Table of Contents

Unit 3: Setup

LOADING THE LABEL ROLL (CONTINUOUS MODE)

The method of installing label media varies with your choice of the two possible print modes—

continuous or dispense mode.

1. Make sure you can see the red platen roller. If not, slide the dispenser unit down, by lifting

its top edge (Tear-off bar) upwards at the two arrow marks. Now push the dark gray Cover

Open/Close lever downwards to release the cover.

2. While pressing the label guide stopper, slide the label guide to the width of the label roll

being loaded. (Note the measurement on the inside of printer.)

Page 3-12

Continuous mode

Label

Figure 3-12, Continuous Mode

Dispenser unit

Figure 3-13, Sliding Dispenser Unit Down

Label guide stopper

Figure 3-14, Adjusting Label Guide Stopper

Journal paper/

Linerless label

MB400i/MB410i Operator Manual

Table of Contents

Mb410i