Unit 3: Setup
5. Close the cover after confirming that the leading edge of the label is outside the printer.
This completes the label installation for continuous mode operation.
LOADING THE LABEL ROLL (DISPENSE MODE)
For operating in the Dispense mode, the following label loading procedures apply.
Figure 3-19, Adjusting Printer Until You Can See Red Platen Roller
Page 3-14
Figure 3-17, Closing the Cover
Dispense mode
Label
Figure 3-18, Dispense Mode
Dispenser unit
Linerless Label
with perforation
MB400i/MB410i Operator Manual