Chapter 5: Getting Started; Before You Begin; Accessing The Web-Based Configuration Utility - Cisco WAP200 Administration Manual

Getting Started

Before You Begin

Accessing the Web-Based Configuration Utility

STEP 1
STEP 2
STEP 3
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster
The Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and
Rangebooster works right out of the box with the default settings. However, you
can change these settings using the WAP200 web-based configuration utility.
Before you begin to use the WAP200 web-based configuration utility, make sure
that you have a computer that meets the following requirements:
• Internet Explorer (version 6 or later) or Mozilla Firefox.
• Your computer is connected to the same network as the WAP200. By
default, the WAP200 access point has an IP address of 192. 1 68. 1 .245 and a
default mask of 255.255.255.0.
To access the WAP200 configuration utility, follow these steps:
Start a web browser. In the Address bar, enter the default IP address of the
WAP200: 192.168.1.245.
When the login page appears, enter the user name and password.
The default user name is admin.
The default password is admin. Passwords are case sensitive.
Click OK.
5
15