I
Fig. 9.3
9.3
Reassembly the external
panels
Side panels
Fit the external panels E and G in the re-
verse order to that described on section
"Dismantling the external panels" to page
74.
Front panel
• Fit the front panel D, hooking it on the up-
per side.
• Push the spring towards the internal side
of the boiler and simultaneously push the
front case panel D until it is completely
hold in place (Fig. 9.4) step 1-2.
• Repeat the same operation on the op-
posite side of the front panel D, (Fig. 9.4)
step 3-4.
• Ensure that the front panel edge is close-
fitting to the side panels.
• Lock in place the panel D with the appro-
priate screws A (Fig. 9.1.
MAINTENANCE
G
Fig. 9.4
9.4
• Turn off the d.c.w .inlet isolating valve 7
(Fig. 9.5).
4
Fig. 9.5
E
Emptying the d.h.w. system
7
Close
position
D
8
- 75 -