Receiving A Call; Call Waiting - Chevrolet HHR 2011 Owner's Manual

Using the Digit Dial Command
The digit dial command allows a phone number to be
dialed by entering the digits one at a time. After each
digit is entered, the system repeats back the digit it
heard followed by a tone.
If an unwanted number is recognized by the system,
say Clear at any time to clear the last number.
To hear all of the numbers recognized by the system,
say Verify at any time.
1. Press and hold
2. Say Digit Dial .
3. Say each digit, one at a time, that you want to dial.
After each digit is entered, the system repeats
back the digit it heard followed by a tone. After the
last digit has been entered, say Dial .
Once connected, the person called will be heard
through the audio speakers.
Using the Re dial Command
1. Press and hold
2. After the tone, say Re dial .
Once connected, the person called will be heard
through the audio speakers.
4-76
g
for two seconds.
g
for two seconds.

Receiving a Call

When an incoming call is received, the audio system
mutes and a ring tone is heard in the vehicle.
g
Press to answer the call.
x
Press to ignore a call.

Call Waiting

Call waiting must be supported on the cell phone and
enabled by the wireless service carrier.
g
Press to answer an incoming call when
another call is active. The original call is placed
on hold.
g
Press again to return to the original call.
To ignore the incoming call, no action is required.
x
Press to disconnect the current call and
switch to the call on hold.