Heat & Glo LUX36 Owner's Manual page 63

B. Vent Components Diagrams (continued)
Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be
used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm) the
existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a DVP-HSM-B
will be required.
15-1/8 in.
(384 mm)
DVP-TRAP
Horizontal Termination Cap
Figure 16.4 DVP vent components
8 in.
(203 mm)
12 in.
(305 mm)
DVP-TRAP1
DVP-TRAPK1
Heat & Glo • LUX36, LUX42 • 2287-900
Heat
Shield
Term Cap
Max
Trap1
Effective
Length
Trap2
DVP-TRAP2
DVP-TRAPK2
• 2287-900 Rev. J Rev. J • 6/13
Minimum Maximum
Effective Length Effective Length
3-1/8 in. 4-5/8 in.
79 mm 117 mm
5-3/8 in. 9-3/8 in.
137 mm 238 mm
63