Heat & Glo LUX36 Owner's Manual page 53

Replacing Fixed Glass Assembly
This fi xed glass assembly is held in place by three lower
glass clips, two side clips and one top retaining rail. To re-
move clips, engage the spring clips with the tool and pull
tool out slightly. Rotate wrist left and right to disengage
clip. The glass clip tool is shown in Figure 14.1.
1. Tool is fastened to the lower right corner of the fi re-
place. Remove tool by removing one screw. If glass
clip removal tool becomes misplaced, a cotter pin re-
moval tool may be used.
2. Position the fi xed glass assembly so that it is about
eight inches from the face of the appliance. See Fig-
ure 14.4.
Figure 14.4. Position Glass
3. Center the fi xed glass assembly from left to right in-
side the top of the appliance opening. Align the notch
at the top center of the glass frame assembly with
the notch on the top retaining rail. The glass frame
has tabs on the bottom that coincide with the bottom
glass clip location. The LUX36 has three tabs and the
LUX42 has four tabs. If the glass is not centered, it
can not be installed properly. See Figure 14.5.
4. Install fi xed glass assembly by lifting it up and sliding
it into the top retaining rail. Grasp the fi xed glass as-
sembly on the sides.
TOP RETAINING RAIL NOTCH TOP RETAINING RAIL NOTCH
GLASS FRAME NOTCH GLASS FRAME NOTCH
Figure 14.5. Align Notches
CAUTION! Risk of Injury! DO NOT put fi ngers under
glass frame. Fingers may get pinched by glass frame
during installation.
Heat & Glo • LUX36, LUX42 • 2287-900 • 2287-900 Rev. J
Once the glass is installed fully into the top retainer
rail, push in the bottom so that the glass assembly
rests on the three support tabs on the glass clip. See
Figure 14.6.
5. Ensure that the fi xed glass assembly is situated tight
against the fi rebox face. Engage the left and right
glass clips using the glass clip tool. See Figure 14.7.
6. Once the left and right glass clips are installed, en-
gage the bottom clips by inserting the glass clip tool at
a sharp downward angle to get between the gap be-
tween the glass frame and the front bottom fi replace
lip. Engage all bottom glass clips. See Figure 14.8.
7. Return glass tool to its shipping location in the low-
er right corner of the appliance and secure with one
screw.
GRASP FRAME BY LIP THAT GRASP FRAME BY LIP THAT
PROJECTS FROM GLASS. DO NOT PROJECTS FROM GLASS. DO NOT
INSERT FINGERS UNDER RAIL. INSERT FINGERS UNDER RAIL.
Figure 14.6. Install Glass
Figure 14.7. Fasten Side Glass Clips
Figure 14.8. Fasten Lower Glass Clips
Rev. J • 6/13
LIP LIP
RAIL RAIL
53