Samsung SRP-350 Operator's Manual page 23

0 ≤ y ≤ 255
[Description] Sets the horizontal and vertical motion units to approximately 25.4/x mm {
1/x inch and } and approximately 25.4/y mm {1/y inches}, respectively.
When x and y are set to 0, the default setting of each value is used
• GS V m , • GS V m n
[Name] Select cut mode and cut paper.
[Format] • ASCII
Hex
Decimal
• ASCII
Hex
Decimal
[Range] • m = 1, 49
• m = 66, 0 ≤ n ≤ 255
[Description] Selects a mode for cutting paper and executes paper cutting.
The value of m selects the mode as follows:
M Print mode
0, 1, 49 Partial cut (one point left uncut)
66 Feeds paper (cutting position + [n × (vertical motion unit)]), and
cuts the paper partially (one point left uncut).
GS W nL nH
[Name] Set printing area width.
[Format] ASCII
Hex
Decimal
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description] Sets the printing area width to the area specified by nL and nH.
The printing area width is set to [(nL + nH × 256) x horizontal motion
unit)] inches.
GS \ nL nH
[Name] Set relative vertical print position in page mode
[Format] ASCII
Hex
Decimal
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description] Sets the relative vertical print starting position from the current position in
page mode.
This command sets the distance from the current position to [(nL + nH
x
256) x vertical or horizontal motion unit] inches.
GS V
1D 56
29 86
GS V
1D 56
29 86
GS W nL
1D 57 nL
29 87 nL
Left margin Printing area width
GS \ nL
1D 5C nL
29 92 nL
m
m
m
m n
m n
m n
nH
nH
nH
Printable area
nH
nH
nH