FujiFilm FinePix 2600Zoom Service Manual page 19

FinePix2600Zoom (U/E/EG) SERVICE GUIDE
<Step 5>
Select Hardware from the Customize Setup Screen (Fig.I-
(1)). Setup as follows on the Hardware menu (Fig.I-(2)).
Item
Debug mode
<Step 6>
When setup on the three menus noted above (EVR, Etc, Hard
ware) is complete, click on Apply (Fig.I-(3)) on the Customize
dialog screen to finish.
After the setup has been applied, further setup is unnecessary.
Note:
Setting Disable OKNG Display to OFF on the screen shown in
Fig.H displays OK on the screen if adjustment is OK, and NG if
not (either setting may be entered).
Cautions When Adjusting
*1) FinePix2600Zoom cannot adjust the EVR data reading
and writing.(Details are right tables.)
*2) End Setting returns the camera from the Jig mode to
the Product Mode (see P27/28).
End Setting is required when using the PC adjustment
software, even when replacing boards or units other
than those noted above. Failure to run End Setting will
prevent identification as Mass Storage.
When the camera is connected to the PC, and prevent
communication with the PC.
*3) When all adjustment have been completed, always
check that the camera is identified as Mass Storage.
*4) Start from Picture adjustment absolutely when you
exchange LENS ASSY and MAIN PWB ASSY.
Setup. details
Select Ignore Focus
4. Adjustment and Inspection
(2)
<Fig.I> Hardware Dialog Box Screen
Menu Command
Operation Start
Stop
Temporary stop Temporary program stop
Step 0
End
Program Reload
Select
Edit
Data ad[ ]
rd[ ]
SW
fsw
EVR
Mode File record
NGSTOP
STEP
LINE
AUTO
Setting OKNG clear
Mode set
Automaticadjustment Execution setting for Auto
Help Help
FF help
Focus
Version
<Table> FFW217.exe Commands
(1)
fx2600z_ue
Apply
(3)
Details
Program start
Program stop
Do not use
Terminate program
Program (*.ff) reload
Program (*.ff) select
Program (*.ff) edit
Do not use
Do not use
Do not use
Do not use
Do not use *1)
Do not use
Program stopped if
adjustment is NG
Do not use
Do not use
Do not use
Do not use
Sets up mode
Adjust in user program
Basic software help
User program help
Not used with this
adjustment software
Version information for
basic software
Revised:3.Sep.2001
19