Kyocera 6500i Operation Manual page 151

DSM Scan (Windows Server 2008 R2 Only)
A scanned document can be automatically saved in any format or sent to any destination by reading a
ScanProcess from Active Directory.
NOTE:
• If you are performing DSM scan, check the items below.
• The machine is connected to an Active Directory on the network that the Scan Process can reference.
• DSM Scan and LDAP are set to [On] in Protocol Detail (page 9-98) in Network.
• SSL is set to [On] in Secure Protocol (page 9-101) in Network.
• [Network Authentication] is set in User Login (page 10-2) in User Login Setting.
• If the Active Directory that the Scan Process can reference is not on the network authentication server,
DSM must be set in Command Center RX. For details, refer to the Command Center RX Operation Guide.
DSM Scan - Selecting Scan Process
Select the scan process and press [OK].
Scan Process Name
ScanProcess001
ScanProcess002
ScanProcess003
ScanProcess004
ScanProcess005
Cancel
Status
1
NOTE:
screen may appear. In this event, press [Cancel] to
display the screen for sending.
2
3
4
5
Reload
1/1
Detail
Back OK
10/10/2010 10:10
6
7
6-32
Press the Send Key.
Displays the screen for sending.
Depending on the settings, the address book
Place the originals in the document processor or on
the platen.
Press [WSD Scan/DSM Scan].
If WSD Scan (page 9-100) is set to [Off] in the
network settings, press [DSM Scan] and go to step 5
Press [DSM Scan] and press [Next].
Select the ScanProcess to be used and press [OK].
Press [Reload] to reload the ScanProcess list.
To check the settings, press [Detail].
Change the settings and add destinations as needed.
Only e-mail addresses can be added as destinations.
In the send base screen, press [Detail/Edit],
[Destination], and then [Address Book] or [E-mail
Addr Entry], and add a destination.
In some Scan Processes, it may not be possible to
change settings or add destinations.
Press the Start key. Sending begins.
Sending Functions