Installing The 34Dvi Log Set; Installation Section - Montigo DelRay Tuscany 34DVI Installation & Maintenance Manual

Installing the Log Set
Installing the logs: Model# 34DvI
The tuscany is supplied with five ceramic fibre logs. Unpack the logs
and handle them very carefully.
1. Remove the door cover and the glass door.
left log
Figure 13a. Tuscany's five piece logset.
2. The back log is factory-installed along with the ceramic brick liner
as shown below in figure 12b.
3. Place the Front log onto the front log rest as shown in figure 12c.
The log has lip on the bottom which fits into the slot on the log
rest.
Figure 13b. Back log placement.
Figure 13c. Front log placement.
P/N XG0515

Installation Section 8

Back log
centre log
right log
Front log
Back log
Front log
4. Place the left, centre, and right logs in sequence from left to
right as shown in figures 13d, 13e, and 13f.
5. Start the fireplace. If the flame appears satisfactory, replace the
glass door. If the flame does not appear satisfactory, double-
check the air inlet and exhaust outlet pipe to ensure that they are
unobstructed.
left log
Figure 13d. Left log placement.
Figure 13e.Centre log placement.
Figure 13f. Right log placement.
nOTES:
 I f logs are not placed properly, excessive sooting will
result.
 T he surface of the logs will crack due to the heat from the
flames. This is a normal occurance.
Tuscany
Gas Fireplace Insert
centre log
right log
Page 9