Installing/Removing/Using The Walker Holder; Installing/Removing The Walker Holder - Invacare Pronto M41 Owner's Manual

Clamp
Knob
Upper Support
Clamp
Knob
Lower Support
Protective
Caps
NOTE: Seat not shown.
FIGURE 13.2 Installing/Removing the Oxygen Holder

Installing/Removing/Using the Walker Holder

After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely.
The installation of the walker holder onto the back of the wheelchair seat increases
the length of the wheelchair up to nine inches. When turning the wheelchair it is
important to take note of this increased length - otherwise, injury and/or damage to
surrounding property may result.
NOTE: For this procedure, refer to FIGURE 13.3 on page 68.

Installing/Removing the Walker Holder

NOTE: Reverse this procedure to remove the walker holder.
NOTE: The Crutch/Cane Holder, Oxygen Holder, and Walker Holder all install into the accessory
tube. Only one of these may be installed at a time.
1. If necessary, loosen but do not remove the mounting knob.
2. Install the walker holder into the accessory tube.
3. Thread the mounting knob into the welded nut on the accessory tube. Securely tighten.
Part No. 1143206
Protective Caps
Welded
Nut
INSTALLATION WARNINGS
67
SECTION 13—ACCESSORIES
Welded Nut
Clamp
Knob
Mounting
Tube
Clamp
Knob
Pronto® M41 with SureStep®
Accessory
Tube
Mounting Nut
Welded Nut
Mounting Bolt
Mounting Hand
Knob