Table of Contents
Advertisement
Pro gram ming the User- Selectable Fea tures
1. Write down the column (across) number and row (down) number of the feature(s) you
wish to program.
2. Turn the ignition to the "ON" position or start the engine.
3. Enter the factory preset valet code of "2" by pressing the PlainView 2 Switch's
twice, then press the unmarked button.
4. Press and hold the
for about 3 seconds until you hear one siren chirp and the LED turns
on to acknowledge program mode entry. The system is now in the "Feature Select"
position for User-Programmable Features.
5. Select the feature column: Press the unmarked button the same number of times as the
column number. Pause. You will then hear the same number of chirps as the column
number you have selected, audibly confirming your selection.
6. Within five seconds, select the feature row: Press and release the
number of times as the feature's row number. You'll hear a chirp each time you press the
button to help you count.
7. Pause. You will hear either one or two chirps: two chirps = ON, one chirp = OFF.
8. You can select another feature, or you can exit program mode:
a.
To select another feature in that same column, repeat step 6 within the next five
seconds (after five seconds, three chirps indicate that the ACE 2000 is now back in the
"Feature Select" position).
b.
To select a different feature column, repeat step 5.
c.
To exit program mode, turn the ignition off (you'll hear three chirps and the LED will
turn off to indicate exit of program mode)or wait 60 seconds to automatically exit.
button the same
14
button
Advertisement
Table of Contents
