Table of Contents
Advertisement
Num ber of LED
flashes be tween
pauses
2 flashes
4 flashes
5 flashes
6 flashes
7 flashes
10 flashes
5. If a sensor is often activated, decrease that sensor's sensitivity (or reposition the sensor, if
necessary). If a certain trigger is often activated, check pin switch operation, verify that
the pin switch is not exposed to moisture and check the trigger wire for possible shorting.
Tazor 4 comes from the factory with its features preprogrammed as noted in bold text in the
tables on pages 15 and 16. Some features can be programmed by the installer or the user,
others can only be programmed by the installer. There are two tables provided which define
the user-programmable and installer-programmable features.
The CliffNet Wizard provides almost intuitive access to all installer and user-programmable
features through a user-friendly, graphical user interface. Because CliffNet Wizard Pro is
Windows™-compatible, most operations can be accomplished by simply pointing and clicking
a mouse. CliffNet Wizard Pro totally eliminates complicated programming charts and lengthy
programming sequences. Please refer to the CliffNet Wizard Pro User's Guide for more
programming information if you are using the CliffNet Wizard Pro. Otherwise, for manual
programming refer to the tables provided in the following sections.
Pro gram ming the User- Selectable Fea tures
1. Write down the column (across) number and row (down) number of the feature(s) you
wish to program.
2. Turn the ignition to the "ON" position or start the engine.
3. Enter the factory preset valet/programming code of "2" by pressing the PlainView 2
Switch's
button twice, then press the unmarked button (you are now in valet mode).
4. After entering the code, press and hold the
chirp and the LED turns on to acknowledge program mode entry. The Tazor 4 is now in
the "Feature Select" position for User-Programmable Features.
5. Select the feature column: Press the unmarked button the same number of times as the
column number. Pause. You will then hear the same number of chirps as the column
number you have selected, audibly confirming your selection.
6. Within five seconds, select the feature row: Press and release the
number of times as the feature's row number. You'll hear a chirp each time you press the
button to help you count.
7. If there is a NOTE for the selected feature, perform the actions noted.
8. Pause. You will hear either one or two chirps: two chirps = ON, one chirp = OFF.
9. You can select another feature, or you can exit program mode:
a. To select another feature in that same column, repeat step 6 within the next five
seconds (after five seconds, three chirps indicate that the Tazor 4 is now back in
the "Feature Select" position).
b. To select a different feature column, repeat step 5.
Trig ger/sen sor in di ca tion
Dual-Zone Piezo Sensor
Door Trigger
Trunk Trigger/Hood Trigger (trunk only, if IntelliStart 4 has been
installed)
Hood Trigger (only if optional IntelliStart 4 has been installed)
An attempt was made to turn on the
ignition or start the engine while the system was armed
System Power Interruption
Pro gram ma ble Fea tures
Us ing the Cliff Net Wiz ard Pro
for about 3 seconds until you hear one siren
13
button the same
Advertisement
Table of Contents
