Sony DynaView SSC-CR441 Operating Instructions Manual page 56

Shortcut key (+Preset)
99+ Preset
111 - 122+ Preset
124 - 175+ Preset
Shortcut key (+Set Preset)
1 - 32+ Set Preset
35 - 66+ Set Preset
83+ Set Preset
90+ Set Preset
91+ Set Preset
92+ Set Preset
93+ Set Preset
95+ Set Preset
111 - 122+ Set Preset
124 - 175+ Set Preset
– only 128 points can be preset such as 1-32, 35-66, 111-122, 124-175.
– there are 107 points preserved for future use such as 67-69, 81-87, 90-94, 100-110, 123, 176-255.
Tips
• + Preset: press the PRESET key once, for example: <Begin auto scan>: press number key
99, and then press the PRESET key.
• + Set Preset: press and hold the PRESET key for 3 seconds, for example: <Open OSD
menu>: press number key 95, and then press and hold the PRESET key for 3 seconds.
• Explanations about keypad operations in this manual are based on the Pelco KBD300A.
56
Preset Commands
Function & Action
Activate auto scanning
Move the camera to the preset points if the points are
preset, the set words is displayed.
Move the camera to the preset points if the points are
preset, the set words is displayed.
Function & Action
Configure the P/T/Z position, "ACCEPT" blinking on
the screen
Configure the P/T/Z position, "ACCEPT" blinking on
the screen
Enter privacy zone 1-8 setup mode
Set Joystick left limit, "MANUAL LEFT LIMIT"
appears on the screen.
Set Joystick right limit, "MANUAL RIGHT LIMIT"
appears on the screen.
Set scan left limit, "SCAN LEFT LIMIT" appears on
the screen.
Set scan right limit, "SCAN RIGHT LIMIT" appears
on the screen.
Open OSD menu
Configure the P/T/Z position, "ACCEPT" blinking on
the screen
Configure the P/T/Z position, "ACCEPT" blinking on
the screen