BASKET ALIGNMENT
INSTRUCTIONS
Basket Alignment Instructions
Step 1
Loosen the set screws on the flange and pillow block
bearings.
Step 2
Loosen the 4 side bolts, "1, 2, 3, 4" on the basket
bearing bracket. (see figure 3) Loosen the two adjusting
bolts and locknuts "5, 6" inside the bracket. Loosen the
bolts "7" on the pillow block bearing.
Step 3
Place one "A" and two "B" diameter pins inside the
drying compartment between the rim of the basket
opening and the rim of the door opening in the positions
shown in figures 1 and 2. Check the two "B" pins for
equal clearance.
NOTE
Push the basket toward the rear
Step 4
With the pins in position, tighten the set screws on the
bearing races.
Step 5
Tighten the side bolts "1, 2, 3, 4" in numerical order.
Tighten the bolts "7" on the pillow block bearing. And
tighten the bolts "5" and locknuts "6."
Step 6
Remove the aligning pins.
CAUTION
Check to see that the set screws are wrench tight on the
bearings.
Page 46