Bearing Replacement Instructions - IPSO DR30SLG Owner's Manual

BEARING REPLACEMENT
INSTRUCTIONS

Bearing Replacement Instructions

Step 1 Remove belt guard, V-belt, spacer and basket
sheave.
Step 2 Loosen set screws on the flange bearing and on the
pillow block bearing.
Step 3 Remove the bolts holding the pillow block bearing
and take it off the shaft.
Step 4 Remove the nuts and washers holding the flange
basket bearing and take it off the dryer.
Step 5 Inspect the bearings for damage and replace as
necessary, in reverse order of removing them. Before
tightening securely, align basket per instructions on
separate instruction sheet.
Step 6 Lubrication guide---Bearings never need lubrication.
They have been permanently lubricated by the
supplier with a high temperature grease.
Page 45