Loading A Project - Roland VM-7000 Getting Started

®ÂØÒňΠApplication Guide
©
2000 Roland Corporation U.S.
Projects (Continued)
When you re-name a project, you change its name in the VM-7000's
memory, not in the project file on the card. To make this change
permanent, you'll need to update the project file. We'll describe how to
do this in the next section of this application guide.
On this screen—though you don't want to do this now—you can also
protect the project from unintentional changes by engaging its memory-
protect function. If you wish to activate memory protection, press F6
[PROTECT]. To de-activate it, press F6 [PROTECT] again. Remember,
however, that when memory protection is active, you can't update the
project with your latest settings until protection has been de-activated.
Updating/Storing a Project
When you make changes to a project—by changing your settings in the
VM-7000, or by re-naming the project, for example—you'll want to store
these changes in the project file on your memory card by updating, or
"storing," the project. When you perform this procedure, the latest
version of the project—including your new changes—replaces the
version currently on the card.
To store a project:
1. Press PROJECT.
2. Make sure the row of icons that includes STORE is selected.
3. Press F1 [STORE].
4. A box appears in which you can see the project's name—"My
Project"—and its comment, "Tutorial."
5. Press F2 [STORE].
The VM-7000 asks you to confirm your desire to update the project.
6. Press F5 [OK] to proceed.
7. Press F6 [EXIT] after the project's been saved.

Loading a Project

To load a project stored on a memory card:
1. Press PROJECT.
2. Make sure the row of icons that includes SELECT is chosen.
3. Press F1 [SELECT].
A screen appears in which the projects stored on the memory card
are displayed.
4. Turn V1 [SELECT NUMBER] to choose the project you wish to
load—if there's only one project, as in our example, turning this
knob will have no effect.
5. Press F2 [SELECT].
The VM-7000 will ask you to confirm your intentions, reminding you
that the settings in the project you're about to load will replace the
system's current settings. If you'd like to preserve your current
settings, press F6 [CANCEL] and save your current settings as a
new project before loading the project selected in Step 4.
6. Press F5 [OK] to load the project.
7. Press F6 [EXIT] once the project's finished loading.
When you power up the VM-7000, it automatically reloads the last-
loaded project if the memory card that holds it is installed in the
MEMORY CARD slot.
Getting Started with the VM-7000
Getting Started with the VM-7000
2796US, v1.0 Page 48