Table of Contents
Advertisement
®ÂØÒňΠApplication Guide
©
2000 Roland Corporation U.S.
The CH EDIT Buttons (Continued)
Here's how to use QUICK CH EDIT:
•
Hold down a channel's CH EDIT button for a
moment, and, without letting go, press the desired
QUICK CH EDIT button. Release both buttons
when the desired parameter screen appears.
When working with Flex Bus channels, only STATUS
buttons 19-24 invoke QUICK CH EDIT parameter
screens.
XVI.
The STATUS and MODE Buttons
At the top of each channel
strip you'll find a STATUS
button with the channel's
number printed above it.
The STATUS buttons work together with the MODE
buttons located to their right. These buttons let you:
•
mute a channel by silencing its signal.
•
solo a channel by silencing all other channels.
•
send a channel's audio signal into the main stereo mix.
•
place an external recorder track in record-ready mode so that you
can record the channel's audio on the track.
•
place an external recorder track in playback mode so that you can
play back the channel's audio that's been recorded on the track.
•
use the VM-7000's Automix automation feature to record and play
back changes you make to channel parameter values.
What the channel STATUS buttons do depends on which MODE and
SECTION button is lit. In each case, the color of the STATUS button—or
the fact that it's not lit at all—tells you the channel's current status.
•
When MUTE is lit, you can press a channel's STATUS button to
silence the channel (red), or turn it back on (unlit). This doesn't
apply to multi out channels, which can't be muted.
•
When SOLO is lit, you can press a channel's STATUS button to solo
the channel (amber), or un-solo it (unlit). This doesn't apply to multi
out channels, which can't be soloed.
•
When AUDIO is lit, what the STATUS buttons do depends on the
type of channel you're working with:
•
When you're working with input, multi in or Flex Bus channels,
you can press STATUS to send a channel's signal into the main
stereo mix (green) or not (unlit).
•
When you're working with fader group channels, pressing
STATUS has no effect.
•
When you're working with multi out channels, you can press
STATUS to record-enable the corresponding track on an
external recorder (red), or set it to playback (green).
•
When AUTOMIX is lit, you can press STATUS to begin recording
changes you make to parameter values (red), play them back
(green), or turn off Automix for the channel (unlit).
When we refer to a STATUS button from here on, we'll show the lit
MODE button in parentheses—as in (AUDIO) STATUS—where relevant.
Getting Started with the VM-7000
Getting Started with the VM-7000
2796US, v1.0
For example, to jump to an
input channel's preamp
parameters, hold down its
CH EDIT button and press
the PREAMP GAIN STATUS
button.
Page 13
Advertisement
Table of Contents
