Roland VM-7000 Getting Started page 41

®ÂØÒňΠApplication Guide
©
2000 Roland Corporation U.S.
Stereo-In, Stereo-Out Effects (Continued)
Set Up the Effect's Routing
1. Turn V2 [POSITION] to select INS ON FBUS INTERNAL.
2. Turn V1 [CHANNEL SELECT], if necessary, to select BUS 1. We
can use Flex Bus 1 since we know it's currently set to INT.
3. Press F1 [SET] to activate the new setting.
4. Press CURSOR DOWN once to select the right side of Effect 1.
5. Turn V2 [POSITION] to select INS ON FBUS INTERNAL.
6. Turn V1 [CHANNEL SELECT], if necessary, to select BUS 2. We
also know that Flex Bus 2 is currently set to INT.
7. Press F1 [SET].
The left and right sides of Effect 1 are now inserted on Flex Busses
1 and 2, respectively.
Select an Effect Library
1. Press EFFECTS 1-8.
2. Press F1 [LIBRARY].
3. Turn V2 [SELECT NUMBER] counter-clockwise to select
P003:StPS-Delay.
4. Press F2 [CP/LOAD].
Send Signals to the Effect
We need to send each of our signals to the desired Flex Bus:
1. Press INPUT CH 1-24.
2. Press the round FLEX BUS 1 button so that we can send Input
Channel 1 signal to the left side of the effect
3. Set Input Channel 1's send to 100, and bring Input Channel 2's
send all the way down.
4. Press the round FLEX BUS 2 button so we can send Input Channel
2's signal to the effect's right side.
5. Bring up Input Channel 2's send to 100.
Edit the Effect
1. Press EFFECTS 1-8 and F2 [EDIT].
2. Cursor down to Direct Level and turn V2 [Direct Level] to set Direct
Level to 0 so that none of the original signal is heard in the effect.
Adjust Your Effect-Related Levels
In our example, we have the following level controls:
1. Sends from
Input Channels
1 and 2
Flex Bus 1
Flex Bus 2
We're going to leave our send levels from the input channels to Flex
Busses 1 and 2, our Flex Bus master levels and our effect input and
output levels as they are. However, we do need to make some changes
to the way our Flex Busses are being sent into the main mix.
Getting Started with the VM-7000
Getting Started with the VM-7000
3. Effect input levels 4. Effect output levels
Effect 1
2. Flex Bus master levels
5. Send from Flex
Busses 1 and 2
into main mix
Flex Bus 1
Flex Bus 2
2796US, v1.0 Page 41