Insert With Positive Connection; Insert With Direct Connection (Masonry Fireplace) - Lopi Revere Owner's Manual

12
Insert with
Positive
Connection
NOTE:
Most factory-built
chimney manufacturers
make stainless steel
chimney liners, either
flexible or rigid. This
provides a wide variety
of installation options.
Make sure to follow the
manufacturer's
instructions for
installation and
support.
Insert with Direct
Connection
(Masonry
Fireplace)
NOTE:
Direct connections
require installation of
an airtight block-off
plate or damper
adapter (see "Block-off
Plate Installation" on
page 11).
© Travis Industries
Stove Installation
Install a non-combustible
cover plate to prevent water
from entering the chimney
NOTE: This installation may be
used with a masonry or zero
clearance fireplace. The
requirements in the section
"Masonry Fireplace Requirements"
or "Zero Clearance Fireplaace
Requirements" must be fulfilled
prior to installation.
Combustible Mantle
Surround Panels
See the section "Insert
Placement Requirements" for
minimum clearances and
hearth required.
NOTE: This installation may be
used with a masonry or zero
clearance fireplace. This
illustration depicts a masonry
insert, all requirements in the
section "Masonry Fireplace
Requirements" must be fulfilled
prior to installation.
Combustible Mantle
Surround Panels
See the section
"Insert Placement
Requirements" for
minimum clearances
and hearth required.
(for qualified installers only)
100-01165
Cap (prevents water
from entering)
Flue Liner
The liner must be
stainless steel
connector or flexible
vent. Follow the liner
manufacturer's
insturctions for
installation and
support.
Airtight Insulated
Clean-Out
Remove damper
or wire it open
Figure 7
Flue
Liner
Stainless steel
chimney connector
must Extend 1' past
the block-off plate or
to the flue liner
Airtight
Insulated
Clean-Out
Remove
damper
or wire it
open
Block-off plate or
damper adapter
4040806