Rear Vent Configuration With Horizontal Termination (With Vertical Rise) - Lopi 564 GSR2 25K CF Installation Manual

26 Finalizing the Installation

Rear Vent Configuration with Horizontal Termination (with vertical rise)


The termination must fall within the shaded area shown in the chart. Use the indicated restrictor and
diffuser positions.

Up to four elbows (45° or 90°) may be used.

Only one horizontal elbow may be used.

Use 8" diameter vent.
22' max (6.7 m)
20 feet (6 m)
15 feet (4.5 m)
10 feet (3 m)
5 feet (1.5 m)
0 feet
This is considered a horizontal
elbow (it does not matter
whether it turns right or left).
It may be a 90° or 45° elbow.
© Travis Industries
Exhaust Restrictor # 5
Intake Restrictor # 2
Diffuser Position # 2
Exhaust Restrictor # 4
Intake Restrictor # 2
Diffuser Position # 2
Exhaust Restrictor # 1 (stock)
Intake Restrictor # 1 (stock)
Diffuser Position # 1 (stock)
- Remove the Exhaust Restrictor
and Install Exhaust Deflector
- Intake Restrictor # 1 (stock)
- Diffuser Position # 1 (stock)
H2
H1
5/15/2019 - 1508
(for qualified installers only)
Exhaust Restrictor # 2
10 feet (3 m)
Intake Restrictor # 1 (stock)
Diffuser Position # 1 (stock)
Horizontal length is calculated by adding
both lengths of horizontal run
(Horizontal Length = H1 + H2).
This is considered a
vertical elbow
564 GSR2 25K CF (AUST)
22' max (6.7 m)
20 feet (6 m)
15 feet (4.5 m)
5 feet (1.5 m)
0 feet