4.0
Mounting
Do not use this product in outdoor
applications.
1. Install a 10 cm (4 in.) square or octagonal electrical
box (not supplied) to a rigid surface that is not
subject to movement or vibrations.
If you are not mounting these detectors to an
electrical box, ensure the surface cannot move or
vibrate. For example, do not mount the detector
directly to a suspended ceiling without extra
support.
2. Remove the screw on the receiver's access door.
Then remove the cover's four screws (refer to
Figure 5).
Figure 5: Access Door and Cover
1
1 - Access door
2 - Cover mounting screw (4)
3. Remove the receiver back plate by unscrewing the
single mounting screw from the top of the circuit
board carrier plate and separating the two plates
(refer to Figure 6).
Figure 6: Removing the Back Plate
1
4
1 - Remove screw to expose the back plate.
2 - Mounting slot (4)
3 - Wiring entrance
4 - Do not remove.
Bosch Security Systems, Inc. | 09/06 | 31344F
4. Route the wiring from the electrical box through the
5. Mount the back plate to the electrical box.
6. Attach the circuit carrier plate to the back plate
7.
2
2
2
3
D296/D297 | Installation Instructions | 4.0
wire entrance.
Unpower (disable) all wiring.
using a single mounting screw.
Repeat Steps 1 through 6 to mount the transmitter.
Mounting
5