Invacare Top End T-3 Tennis Adjustable Operating And Maintenance Manual page 46

PROCEDURE 6
A-4 CAMBER TUBE ONLY - NEVER position the camber inserts in the axle
tube with more than 3-inches (12 indexing marks showing) of the camber insert
outside of the axle tube. The camber inserts will not be securely tightened in
the axle tube resulting in possible injury to the user or damage to the wheel-
chair.
12. A-4 CAMBER TUBE ONLY - Install the camber inserts into the new axle tube and slide the
camber inserts to the position noted in STEP 1. Make sure there is no more than 3-inches
(12 indexing marks) of the camber inserts outside of the axle tube.
13. A-4 CAMBER TUBE ONLY - Slide the indexing ring on the camber insert until it is flush
with the frame bracket.
NOTE: To maximize rollability: Before using the wheelchair, make sure both camber inserts are set to the
same indexing notch. This will make sure the distance between the rear wheel and the wheelchair is the
same on both sides.
14. Install the rear wheels onto the wheelchair. Refer to REMOVING/INSTALLING REAR
WHEELS in this procedure of the manual.
15. Determine the toe in/toe out of the wheelchair. Refer to DETERMINING TOE IN/TOE
OUT in this procedure of the manual.
NOTE: The performance of the wheelchair will be affected if the toe in/toe out of the wheelchair is not correct.
Notch in Axle
TubeTwoards Rear
of Wheelchair
Frame
Bracket
Camber Clamp
Camber Insert
Indexing Ring
Frame Bracket
FIGURE 15 - REPLACING AXLE TUBE
T-3™ and T-4™ Series
WARNING
REAR OF
WHEELCHAIR
Adjustment Ring
Camber Tube
Adjustment Ring
46
A-4 CAMBER TUBE
Slot in Axle Tube
Camber Insert
Camber Clamp
CAMBER TUBE
Camber Clamp
Camber Tube
Camber Clamp
Part No. 1054916
WHEELS
2000