Wheelchair Operation; Preparing The Joystick For Use - Invacare TDX SI User Manual

5 Wheelchair Operation

WARNING
After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely -
otherwise injury or damage may result.
Set-up of the Electronic Control Unit is to be performed only by a qualified technician. The final adjustments of the
controller may affect other activities of the wheelchair. Damage to the equipment could occur under these circumstances.
5.1

Preparing the Joystick for Use

 For this procedure, refer to FIGURE 1.
The joystick is factory installed on the right side of
the wheelchair. To reposition the joystick onto the
left side of the wheelchair, refer to Repositioning
Joystick on page 93.
1. Turn the adjustment lock lever to release the adjustment lock from
joystick mounting tube.
2. Slide joystick mounting tube to the desired position.
3. Turn the adjustment lock lever to secure the adjustment lock to the
joystick mounting tube.
Part No 1154294
Joystick Mounting
Tube
FIGURE 1
39
5 WHEELCHAIR OPERATION

Joystick not shown.
Adjustment Lock
Lever
Preparing the Joystick for Use
Invacare® TDX®SI Series