Advertisement
Rear Frame
Plunger
Assembly
DISASSEMBLING/ASSEMBLING THE PLUNGER
ASSEMBLY - STEPS 4 AND 7
Brake
Plunger
Spring
FIGURE 4 - REPLACING SPARTAN CANES AND BRAKES - REPLACING SPARTAN BRAKES
Assembling Spartan For Use (FIGURE 5)
NOTE: The Spartan rollator should only be assembled
AFTER replacing spartan brakes. Refer to REPLAC-
ING SPARTAN BRAKES in this procedure of the in-
struction sheet.
1. Install tire. Perform the following:
A. Position the tire so the mounting holes are aligned
with the mounting holes in the rollator leg.
B. Install the screw from the inside of the rollator,
through both sets of mounting holes.
REMOVING/
INSTALLING THE
PLUNGER
ASSEMBLY
- STEPS 2 AND 9
Flat
Screwdriver
Brake
Slot
Wire
Wire
Stop
REMOVING/SECURING
BRAKE WIRE STOP
- STEPS 3 AND 8
Lip
Insert
Brake Wire Stop
Slot
Slot Opening
Slot
Opening
Insert
C. Secure the tire to the rollator with the locknut.
Tighten securely.
D. Install the cap covers over the screw and locknut.
2. Perform one (1) of the following:
INSTALLING CANE KIT - Install the push handle. Per-
form the following:
A. Remove the hex bolt, washer and locknut securing
the hand brake to the push handle.
6
THE
Plunger
Flat
Screwdriver
REMOVING/INSERTING
THE BRAKE CABLE
- STEPS 5-6
Brake
Cable
Rear Frame
Advertisement
