Adjusting the Footrest Height
Model PW93, PW93E, and PW93ST Footrests
NOTE: For this procedure, refer to FIGURE 6.2.
1. Remove any accessory from the footrest(s).
2. Remove the footrest from the wheelchair. Refer to Installing/Removing the Footrests
on page 31.
NOTE: Lay footrest on a flat surface to simplify procedure.
3. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the
footrest support.
4. Reposition the lower footrest to the desired height.
5. Reinstall hex bolt, coved washers and locknut that secure lower footrest to footrest
support. Tighten securely.
6. Repeat STEPS 1‐5 for the other footrest, if necessary.
7. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing the
Footrests on page 31.
8. Reinstall any accessory onto the footrest(s).
NOTE: PW93ST style footrest shown. PW93 and PW93E footrests adjust the same way.
FIGURE 6.2 Adjusting the Footrest Height - Model PW93, PW93E, and PW93ST Footrests
Part No.1106645
Locknut
Coved Washer
SECTION 6—FRONT RIGGINGS
Footrest Support
Coved Washer
Hex Bolt
Lower Footrest
32
Nutron® Series