Section 9-Upholstery/Seat Positioning Strap; Replacing Seat Upholstery; Replacing Back Upholstery - Invacare Nutron R50LX Owner's Operator And Maintenance Manual

SECTION 9—UPHOLSTERY/SEAT POSITIONING STRAP
SECTION 9—UPHOLSTERY/SEAT
POSITIONING STRAP
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.

Replacing Seat Upholstery

NOTE: For this procedure, refer to FIGURE 9.1.
1. Remove the eight (8) phillips screws
and washers that secure the existing
seat upholstery to the crossbraces.
2. Remove existing seat upholstery from
the crossbraces.
3. Line up mounting holes in new seat
upholstery with mounting holes in the
crossbraces.
4. Securely tighten with existing phillips
screws and washers.
NOTE: Clean upholstery with warm DAMP
cloth and mild detergent to remove superficial
soil.
Laundering or moisture will reduce flame retardation of the upholstery.

Replacing Back Upholstery

NOTE: For this procedure, refer to FIGURE 9.2.
NOTE: Observe the position and orientation of the back cane mounting hardware before removing.
The fold down back canes use two (2) mounting screws to secure the two (2) back canes to the
wheelchair frame, all other back canes use four (4) mounting screws.
1. Remove the two (2) upholstery mounting screws and washers that secure the existing
back upholstery to the back canes.
2. Remove the screws and locknuts that secure the two (2) back canes to the wheelchair
frame.
3. Remove the two (2) back canes and the back upholstery from the wheelchair frame.
Nutron® Series
WARNING
Phillips Screw
FIGURE 9.1 Replacing Seat Upholstery
WARNING
43
Washer
Seat Upholstery
Part No.1106645