Removing/Installing The Seat Assembly - Invacare Pronto M51 Base Owner's Operator And Maintenance Manual

SECTION 6—SEAT

Removing/Installing the Seat Assembly

NOTE: For this procedure, refer to FIGURE 6.2.
NOTE: This procedure is for wheelchairs WITHOUT the Formula PTO Plus seating system
installed ONLY. For wheelchairs with the Formula PTO Plus seating system, refer to Tilting the
Seat Assembly (Formula CG Only) on page 41.
Removing
1. Disconnect the joystick cable at rear of seat. Refer to Disconnecting/Connecting the
Joysticks on page 44.
2. Push down on the latch bar underneath front of seat.
3. Rotate seat assembly backward.
4. Slide the seat assembly forward to disengage seat from pivot brackets located in the rear.
Installing
1. Position the seat in the rear pivot brackets as shown in FIGURE 6.2.
2. Rotate seat assembly forward.
3. When seat is lowered, engage seat brackets into seat clevis pins.
WARNING
When reinstalling the seat verify that the seat brackets are engaged with the seat
clevis pins by pulling up on the latch bar.
4. Pull up on latch bar to verify that brackets are engaged with seat clevis pins.
Rear Pivot
Brackets
Seat Clevis
Pins
Latch Bar is located
under the front of the
seat
FIGURE 6.2 Removing/Installing the Seat Assembly
43 ® ™ ®
Part No. 1148076 Pronto M51 Base with SureStep