SECTION 7—FOOTBOARD ASSEMBLY
SECTION 7—FOOTBOARD
ASSEMBLY
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair,
make sure that the flip-up footboard is in the upward position.
Limited Clearance Between Footboard and Caster - The user's feet MUST remain
on the footboard while operating the chair. If the user's feet are allowed to rest off
the side of the footboard they may come in contact with the caster possibly result-
ing in injury.
Removing/Installing the Footboard Assembly
Pinch point may occur when rotating the footboard assembly.
NOTE: For this procedure, refer to FIGURE 7.1 on page 45.
Removing
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame by depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.
®
™
Pronto
M51
Base with SureStep
WARNING
WARNING
®
44
Part No. 1148076